Optimal Modifications of Gear Tooth Surfaces - March/April 2011
The article "Optimal Modifications of Gear Tooth Surfaces" appeared in the March/April 2011 issue of Gear Technology.
In this paper a new method for the introduction of optimal modifications into gear tooth surfaces - based on the optimal corrections of the profile and diameter of the head cutter, and optimal variation of machine tool settings for pinion and gear finishing—is presented. The goal of these tooth modifications is the achievement of a more favorable load distribution and reduced transmission error. The method is applied to face milled and face hobbed hypoid gears.
The article "Optimal Modifications of Gear Tooth Surfaces" should appear in the box below, but if you do not see it, you can download it here.