Home | Advertise | Subscribe

Magazine | Newsletter | Product Alerts | Blog

Software-Based Process Design in Gear Finish Hobbing - May 2010

Share |

Are you featured in this article? Put a link on your website!

Archive > 2010 > May 2010 > Software-Based Process Design in Gear Finish Hobbing

The article "Software-Based Process Design in Gear Finish Hobbing" appeared in the May 2010 issue of Gear Technology.

Summary
In this paper, the potential for geometrical cutting simulations—via penetration calculation to analyze and predict tool wear as well as to prolong tool life—is shown by means of gear finish hobbing. Typical profile angle deviations that occur with increasing tool wear are discussed. Finally, an approach is presented here to attain improved profile accuracy over the whole tool life of the finishing hob.

Keywords
hobbing, software, skiving, tool wear, tool life

The article "Software-Based Process Design in Gear Finish Hobbing" should appear in the box below, but if you do not see it, you can download it here.

It appears you don't have a PDF plugin for this browser. No biggie... you can click here to download the PDF file.