Home | Advertise | Subscribe

Magazine | Newsletter | Product Alerts | Blog

Hard Finishing and Fine Finishing Part 1 - September/October 1989

Share |

Are you featured in this article? Put a link on your website!

Archive > 1989 > September/October 1989 > Hard Finishing and Fine Finishing Part 1

The article "Hard Finishing and Fine Finishing Part 1" appeared in the September/October 1989 issue of Gear Technology.

Summary
Profitable hard machining of tooth flanks in mass production has now become possible thanks to a number of newly developed production methods. As used so far, the advantages of hard machining over green shaving or rolling are the elaborately modified tooth flanks are produced with a scatter of close manufacturing tolerances. Apart from an increase of load capacity, the chief aim is to solve the complex problem of reducing the noise generation by load-conditioned kinematic modifications of the tooth mesh. In Part II, we shall deal with operating sequences and machining results and with gear noise problems.

The article "Hard Finishing and Fine Finishing Part 1" should appear in the box below, but if you do not see it, you can download it here.

It appears you don't have a PDF plugin for this browser. No biggie... you can click here to download the PDF file.