Archive > 1993 > September/October 1993 > Maximum Life Spiral Bevel Reduction Design

Maximum Life Spiral Bevel Reduction Design - September/October 1993

The article "Maximum Life Spiral Bevel Reduction Design " appeared in the September/October 1993 issue of Gear Technology.

Optimization is applied to the design of a spiral bevel gear reduction for maximum life at a given size. A modified feasible directions search algorithm permits a wide variety of inequality constraints and exact design requirements to be met with low sensitivity to initial values. Gear tooth bending strength and minimum contact ration under load are included in the active constraints. The optimal design of the spiral bevel gear reduction includes the selection of bearing and shaft proportions in addition to gear mesh parameters. System life is maximized subject to a fixed back-cone distance of the spiral bevel gear set for a specified speed ratio, shaft angle, input torque and power. Significant parameters in the design are the spiral angle, the pressure angle, the numbers of teeth on the pinion and gear and the location and size of the four support bearings. Interpolated polynomials expand the discrete bearing properties and proportions into continuous variables for gradient optimization. After finding the continuous optimum, a designer can analyze near-optimal designs for comparison and selection. Design examples show the influence of the bearing lives on the gear parameters in the optimal configurations. For a fixed back-cone distance, optimal designs with larger shaft angles have larger service lives.

design, spiral bevel, optimization, geometry, kinematics

The article "Maximum Life Spiral Bevel Reduction Design " should appear in the box below, but if you do not see it, you can download it here.

It appears you don't have a PDF plugin for this browser. No biggie... you can click here to download the PDF file.