Northfield Introduces Five-Inch Diaphragm Chuck
June 17, 2011—Northfield Precision has introduced a special five inch diameter diaphragm chuck. This chuck has built in pneumatic hammer to expel morse taper locators. The diaphragm will center the workpiece and pull it into a hard stop. The MT-3 type stops are hardened and ground to 60/63 RC. These stops are ground between centers on a Tschudin grinder to guarantee they will run dead. To remove the stops, an internal pneumatic hammer is actuated to pop them out.
The diaphragm will center the workpiece and pull it into a hard stop.
For more information:
|Northfield Precision Instrument Corporation|