Gleason Adaptive Honing Solutions Save Cycle Times
February 5, 2013— Honing is a fast, well-proven process in the gear manufacturing industry. It is used in high-volume production environments where every second in cycle time counts. For adaptive honing two parameters must be considered, run out and the size of the parts before honing.
Most honing machines are now equipped with a double flank roll tester to check parts before they are honed. Testing helps identify incorrect or damaged parts which can destroy the honing tool or parts with the wrong stock on the tooth flanks. It does not matter if the stock is too big or too small, in both cases it can lead to poor finished quality. With the help of a double flank roll tester these parts can be identified and separated for either scrap or post-treatment. This pre-checking provides three important pieces of information:
By using adaptive strategies for honing, the center distance between the gear and the honing stone is flexible for every single part, depending on the actual conditions. For machining time it is important to have the center distance as short as possible before starting the honing process.
Until now this initial or starting center distance was set up by calculations and theoretical values. Factors considered were the nominal stock/flank and the lowest acceptable pre-machining quality. To avoid potential problems this required a considerable safety distance between the work and the honing stone; meaning, that when the process starts the tool only “cuts” air before it contacts the flanks.
The value Xu in the machining process describes the center distance where the first contacts can happen. In the past this value was fixed for the complete batch of gears.
Adaptive honing changed this situation. By using the double flank tester, all necessary parameters are known; allowing the machine to automatically calculate the optimal Xu value which enables the proper contacts between tool and gear on an individual basis, ensuring every gear is machined with an optimized value.
If the parts are of good incoming quality the Xu can be lower and the cycle time will be shorter. For poorer quality parts or for parts with higher values for the stock, the Xu will be higher.
By using this flexible adaptive process the safety distances can be far lower and therefore the process time will be reduced. Results have shown an average time savings of 10 percent for machining time and a safer and more stable production environment.
Honing is a fast, well-proven process in the gear manufacturing industry. It is used in high-volume production environments where every second in cycle time counts.
For adaptive honing two parameters must be considered, run out and the size of the parts before honing.
For more information:
| Gleason Corporation|
Gleason Corporation’s mission is to be The Total Gear Solutions Provider™ to its global customer base. Gleason is a world leader in the development, manufacture and sale of gear production machinery and related equipment. The Company’s products are used by customers in automotive, truck, aircraft, agriculture, mining, windpower, construction, power tool and marine industries and by a diverse set of customers serving various industrial equipment markets. Gleason has manufacturing operations in Rochester, New York; Rockford, Illinois; Dayton, Ohio; Munich and Ludwigsburg, Germany; Studen, Switzerland; Bangalore; India, and Suzhou, China and has sales and service offices throughout North and South America, Europe and in the Asia-Pacific region. ...Read more Or visit www.gleason.com