national debt - Search Results

Articles About national debt


Articles are sorted by RELEVANCE. Sort by Date.

1 The Politics of Denial (September/October 1996)

A good many things bother me about election years - the annoying sound bites, the negative commercials, the endless political over-analysis. But what bothers me most about the coming election is this: So far (when I'm writing this, it's admittedly early in the campaign) there's little or no talk about what is one of the most critical national issues of the next thirty years - our growing government debt.

2 Industry News (July 2014)

The complete Industry News section from the July 2014 issue of Gear Technology.

3 Taking on Tight Margins in Wind Energy (March/April 2016)

Onshore and offshore wind turbines boast some of the most critical assets in order to run effectively.

4 GT Extras (July 2014)

See the latest video from Slone Gear International, plus read about the gear industry's unsung heroes in the latest blog post.

5 Gear Measurement Traceability and Uncertainty (July/August 2000)

Until recently, there was a void in the quality control of gear manufacturing in this country (Ref. 1). Gear measurements were not traceable to the international standard of length through the National Institute of Standards and Technology (NIST). The U.S. military requirement for traceability was clearly specified in the military standard MIL-STD-45662A (Ref. 2). This standard has now been replaced by commercial sector standards including ISO 9001:1994 (Ref. 3), ISO/IEC Guide 25 (Ref, 4), and the U.S. equivalent of ISO/IEC Guide 25 - ANSI/NCSL Z540-2-1997 (Ref. 5). The draft replacement to ISO/IEC Guide 25 - ISO 17025 states that measurements must either be traceable to SI units or reference to a natural constant. The implications of traceability to the U.S. gear industry are significant. In order to meet the standards, gear manufacturers must either have calibrated artifacts or establish their own traceability to SI units.

6 Rotary Gear Honing (May/June 1987)

Rotary gear honing is a hard gear finishing process that was developed to improve the sound characteristics of hardened gears by: Removing nicks and burrs; improving surface finish; and making minor corrections in tooth irregularities caused by heat-treat distortion.

7 Gear Roll-Finishing (May/June 1987)

In this discussion of gear roll-finishing particular attention is called to the special tooth nomenclature resulting from the interaction between the rolling die teeth and the gear teeth. To eliminate confusion the side of a gear tooth that is in contact with the "approach" side of a rolling die tooth is also considered to be the approach side. The same holds true for the "trail" side. Thus, the side of the gear tooth that is in contact with the trail side of a rolling die is also considered to be the trail side.