rake angle - Search Results
Articles About rake angle
1 Using Hobs for Skiving; A Pre-Finish and Finishing Solution (May/June 1993)
Our company manufactures a range of hardened and ground gears. We are looking into using skiving as part of our finishing process on gears in the 4-12 module range made form 17 CrNiMO6 material and hardened to between 58 and 62 Rc. Can you tell us more about this process?
2 Optimal Choice of the Shaft Angle for Involute Gear Hobbing (November/December 2007)
With reference to the machining of an involute spur or helical gear by the hobbing process, this paper suggests a new criterion for selecting the position of the hob axis relative to the gear axis.
3 Operating Pressure Angle (May 2013)
What is the difference between pressure angle and operating pressure angle?
The complete Industry News section from the May 2013 issue of Gear Technology
5 If You Rebuild It, They Will Buy It (May 2013)
It’s been said that the best ideas are often someone else's. But with rebuilt, retrofitted, re-controlled or remanufactured machine tools, buyer beware and hold onto your wallet. Sourcing re-work vendors and their services can require just as much homework, if not necessarily dollars, as with just-off-the-showroom-floor machines.
6 Grinding Gears for Racing Transmissions (September/October 2009)
When you push 850 horsepower and 9,000 rpm through a racing transmission, you better hope it stands up. Transmission cases and gears strewn all over the racetrack do nothing to enhance your standing, nor that of your transmission supplier.
7 Product News (January/February 2013)
The complete Product News section from the January/February 2013 issue of Gear Technology.
