From April to June 2022, prospective attendees will again have the opportunity to learn about current trends and the latest happenings at Klingelnberg. After so many exhibitions were canceled in 2020 due to the coronavirus pandemic, Klingelnberg took the initiative of launching its own WebSeminar series.
Spur cylindrical gears are usually cut using a hob and therefore present an essentially straight face to which crowning can be added to prevent edge contact. Rather than using a rack or hob, it is possible to cut cylindrical gears with a face mill cutter. In the following presentation, these gears are termed "spurved," i.e. — a contraction of "spur" and "curved."
This proposed standard would not make any recommendations
regarding the required quality for any application. The
intent is to establish standard pre-finish quality classes for typical
finishing operations, which only include the inspection elements
that are important to properly evaluate pre-finish gear
quality as it applies to the finishing operation. It would be the
responsibility of the manufacturing/process engineer, quality
engineer, or other responsible individual to establish the
required pre-finish quality class for their application.