Open Mind Technologies - Search Results

Articles About Open Mind Technologies


Articles are sorted by RELEVANCE. Sort by Date.

1 Product News (March/April 2018)

New machining fluids for automotive, jaw boring rings, virtual machine simulation and coordinate measuring software are highlighted in the March/April 2018 issue of Gear Technology.

2 Product News (August 2018)

The complete Product News section from the August 2018 issue of Gear Technology.

3 IMTS Future Tech (August 2020)

The Digital Manufacturing Revolution Evolves in 2020

4 Industry News (January/February 2017)

News from around the Gear Industry

5 Product News (March/April 2020)

Gleason skiving machines equipped with on-board cutter sharpening; Helios celebrates anniversary of cutter sharpener line; and more product news.

6 Show Stoppers (September/October 2019)

Motion + Power Technology Expo VIP Exhibitors special advertising section.

7 Industry News (August 2018)

The complete Industry News section from the August 2018 issue of Gear Technology.

8 Gear Expo 2017 and ASM Heat Treat 2017 Booth Previews (September/October 2017)

The latest technology on display in Columbus, OH. October 24-26.

9 Product News (July 2017)

The complete Product News section from the July 2017 issue.

10 Industry News (May 2017)

Faydor Litvin, 1914-2017; Michael Goldstein receives AGMA Distinguished Service Award.

11 Product News (September/October 2014)

The complete product news section from the September / October 2014 Issue Gear Technology.

12 Product news (August 2016)

News about the latest products in the industry.

13 Honing of Gears (August 2014)

The honing of gears - by definition - facilitates ease of operation, low noise and smoother performance in a transmission. Honing also contributes to reduced friction in the powertrain. Both the intense cutting (roughing process) as well as the functionally fine- finishing of transmission gears can be performed in one setup, on one machine.

14 Portable Gear Inspection (July 2014)

Compact, custom and portable solutions are gaining more attention in manufacturing today as companies seek out the tools that offer the greatest productivity gains on the shop floor. Gear inspection seems to be following suit.

15 No Compromising on Quality at Allison Transmission (July 2014)

Gleason 350GMS helps put higher quality, more reliable gears into its next-generation TC10 automatic transmission.

16 Industry News (January/February 2013)

The complete Industry News section from the January/February 2013 issue of Gear Technology.

17 Gear Chamfering Robot (January/February 2011)

Banyan Technologies introduces a robotic chamfering device suitable for deburring, chamfering and radiusing the edges of slew bearing ring gears.

18 Alternative Lubrication Methods for Large Open Gear Drives (September/October 1996)

The type of lubricant and the method of applying it to the tooth flanks of large open gears is very important from the point of view of lubrication technology and maintenance. When selecting the type of lubricant and the application method, it is important to check whether it is possible to feed the required lubricant quantity to the load-carrying tooth flanks, This is necessary to avoid deficient lubrication, damage to the gear and operational malfunctions. It is important to determine the type of lubricant, which may be fluid or grease-like. The consistency of the lubricant will have a direct impact on the ability of the lubrication system to feed adequately the lubricant to the gear. The interactions between the common types of lubricant and the lubrication application methods for open gear drives are shown in Fig. 1.

19 CFC Fixtures Increase Productivity in Carburizing, Nitriding and FNC (March/April 2021)

A review of information published recently by manufacturers of CFC fixtures used in heat treating.