I noted with interest the beginning of Gear Technology's three-part series on ISO 9000 certification. I also recently attended Brown & Sharpe's/Leitz gear metrology seminar. Both events caused me to smile and reflect.
"More than half our young people leave school without the knowledge or foundation required to find and hold a job." according to a 1991 report from the U.S. Dept. of Labor. A huge gap exists between the needs of employers (especially in manufacturing) and the training received by most high school students.
What follows is the first of three articles we will be running on ISO 9000 and what it means for the gear industry. This first article will cover what ISO 9000 is, what some of its benefits - and problems - are, and whether your company should be a candidate for this certification process. In our next issue, we will consider the important question of how, when, and if to hire an ISO 9000 consultant. The final article in this series will discuss ways to save money while streamlining the certification process in your company.
ISO 9000 is the latest hot topic in marketing and manufacturing circles. Everyone seems to be talking about it, but few seem to understand it completely. depending on whom one talks to, it's either the greatest thing to hit industry since the assembly line, another cash cow for slick consultants, a conspiracy on the part of Europeans to dominate global markets, or the next necessary step to compete in the global economy of the twenty-first century. It may be all of the above.
Another year has passed and, because of the short term ups and downs of the economy, it's still hard to judge whether we are in an appreciably different place than we were a year ago. The economy doesn't seem to be worse than it was, but it also doesn't seem to be a whole lot better.
What can be done about the rising cost of labor? Mr. Robert Reich, U.S. Secretary of Labor, has already indicated the administration's intention of pushing the minimum wage from $4.25 to $4.50 per hour and indexing it for inflation. That means that every jiggle in the inflation chart will push the minimum wage higher.
Power train designs which employ gears with cone angles of approximately 2 degrees to 5 degrees have become quite common. It is difficult, if not impossible, to grind these gears on conventional bevel gear grinding machines. Cylindrical gear grinding machines are better suited for this task. This article will provide an overview of this option and briefly introduce four grinding variation possibilities.
Forty of Gear Technology's pre-show and show issue advertisers will be exhibiting a wide range of goods and services at AGMA's Gear Expo '93. The exhibition will be held October 10-13 at Cobo Conference & Exhibition Center in Detroit, MI. Below is an alphabetical listing of these advertisers and a preview of what can be seen at their booths.