May/June 1985

Notes From the Editors Desk

May 1, 1985

This issue, our sixth, marks the 1st Anniversary of GEAR TECHNOLOGY, The Journal of Gear Manufacturing.

Advantages of Involute Splines as Compared to Straight Sided Splines

May 1, 1985

Since the design of involute splines and their manufacture requires considerable knowledge, not only of the basic properties of the involute profile, but also of various other elements which affect the spline fit and the sometimes complex principles underlying manufacturing and checking equipment, the question is frequently raised as to why the involute profile is given preference in designing splines over the seemingly simpler straight sided tooth profile.

Gear Tooth Scoring Design Considerations for Spur and Helical Gearing

May 1, 1985

High speed gearing, operating with low viscosity lubricants, is prone to a failure mode called scoring. In contrast to the classic failure modes, pitting and breakage, which generally take time to develop, scoring occurs early in the operation of a gear set and can be the limiting factor in the gear's power capability.

The Design and Manufacture of Machined Plastic Gears

May 1, 1985

The use of plastic gearing is increasing steadily in new products. This is due in part to the availability of recent design data. Fatigue stress of plastic gears as a function of diametral pitch, pressure angle, pitch line velocity, lubrication and life cycles are described based on test information. Design procedures for plastic gears are presented.

Industry Forum

May 1, 1985

This letter is in response to your article asking the readers where their interests lie. The division of Rockwell International where I work has engineering departments in Cicero.

Gear Inspection and Chart Interpretation

May 1, 1985

Much information has been written on gear inspection, analytical. functional. semiautomatic and automatic. In most cases, the charts, (if you are lucky enough to have recording equipment) have been explained.