Case Study of ISO/TS 6336-22 Micropitting Calculation March 1, 2021 Micropitting per ISO standard explained.Read More
Fatigue Strength and Service Calculation of Gears February 22, 2021 Matthew Jaster No Comments Bevel gear design is well-established. Flank geometry optimization is used worldwide to ensure satisfactory low-noise emis...Read More
Facing Down Contact Ratio November 4, 2020 Charles D. Schultz No Comments Before we move on from helix angle restrictions, I want to say a few things about face contact ratio. Soon after the appearance of the first helica...Read More
Visiting Old Friends May 13, 2020 Charles D. Schultz No Comments Seven weeks into the lockdown, we are all looking for “new content.” Even with a full cable “package” there are times when it seems there is nothin...Read More
That Blank Sheet of Paper October 10, 2019 Charles D. Schultz No Comments Does nature hate a vacuum more than a designer hates a blank sheet of paper? We will never know for sure because nature is too busy to write a blog...Read More
Experimental Study on the Pitting Detection Capabilities for Spur Gears Using Acoustic Emission and Vibration Analysis Methods March 1, 2019 An experimental investigation on spur gears to characterize pitting degradation process using monitoring features.Read More
Lessons Learned the Hard Way January 18, 2019 Charles D. Schultz No Comments Chris’ account of p...Read More
Lubrication: Viscosity and Macropitting September 1, 2018 Robert Errichello A reader asks: Is the ISO VG 320 adequate, or should a higher viscosity grade be used? How can we stop macropitting in gear teeth?Read More
Gear Design: More Than Pretty Pictures August 28, 2018 Charles D. Schultz No Comments No one has a drafti...Read More
Planetary Gears: Inside Information July 3, 2018 Charles D. Schultz No Comments The Story So Far Read More Previous 1 2 3 4 5 6 7 Next
RSS
